Filter
Top Products
Getting Started
Setting up
ENGLISH - 17
Removing the projection lens
from the projector
1. Switch off the POWER button on the projector.
2. Rotate the lens cover counterclockwise and remove.
3. While pressing the lens release button, rotate the
projection lens counterclockwise, and remove the
projection lens.
Attaching the projection lens to
the projector
1. Switch off the POWER button on the projector.
When the lens cover is attached, rotate counterclockwise
and remove.
2. Align the guide of the projection lens with the guide
groove in the projector, and then insert the lens.
3. Rotate the projection lens clockwise until it clicks into
place.
4. To attach the slot, align the slot of the lens cover (see *1)
with the arrow tip located on the body of the projector
(see *2). Rotate clockwise until it reaches the arrow’s
end mark (see *3) to attach.
Removing and attaching the projection lens
NOTE:
• Do not touch the lens signal receiver. Dust or dirt may cause
defective contact.
• Do not touch the surface of the projection lens with your bare
hands.
• Store the replaced lens where it will be free from vibration and
impact.
Lens cover
Projection lens
Lens release button
NOTE:
• Make sure the projection lens is attached securely by rotating
the projection lens counterclockwise.
*1
*2
*3
Lens cover