Filter
Top Products
12
- ENGLISH
Important
Information
Precautions for Use
Cautions when transporting
When transporting the projector, hold it securely by its bottom and avoid
z
excessive vibration and impacts. Doing so may damage the internal parts
and result in malfunctions. You can also use the handle grip in the back of
the projector when transporting.
Do not transport the projector with the adjustable feet extended. Doing so
z
may damage the adjustable feet.
If you have purchased a projector with a standard projection lens, please
z
remove the lens cap on the lens before use, and keep it for later use. For
transportation, press and hold the <LENS> button or <LENS SHIFT>
button for more than 5 seconds to make the lens return to the central
position, and then attach the lens cap to protect the lens. If you have
purchased a projector without projection lens, please make the lens
return to the central position, and then attach the lens cover.
Use the handle grip when moving the projector.
z
Cautions when handling the projector
Do not hold the lens or the lens compartment tube when lifting or moving the projector. Doing so may cause
z
damage to the lens and the projector.
Care must be taken when handling the projector; do not drop, bump, subject it to strong forces, or put other
z
things on the cabinet.
Do not hold the lens and the peripheral part.
z
Cautions when installing
Do not set up the projector outdoors.
J
The projector is designed for indoor use only.
z
Do not use under the following conditions.
J
Places where vibration and impacts occur such as in a car or vehicle: Doing so may damage the internal parts
z
and result in malfunctions.
Near the exhaust of an air conditioner or near lights (studio lamps, etc.) where temperature changes greatly
z
(Operating environment
Æ
page 115): Doing so may shorten the life of the lamp or result in deformation of the
outer case and malfunctions.
Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.
z
Be sure to ask authorized personnel or your supplier when mounting the
J
product to a ceiling.
This requires an optional ceiling mount bracket.
Model No.: ET-PKE200H (for high ceilings), ET-PKE200S (for low ceilings),
ET-PKE200B (Projector Mount Base).
Do not install the projector at elevations of 2 700 m (8 858 ft) or higher
J
above sea level.
Failure to do so may shorten the life of the internal parts and result in malfunctions.