Filter
Top Products
ENGLISH - 24
Basic Operation
Projecting an image
1. Switch on the connected devices.
Press the play button of the required device.
2. Press the INPUT SELECT buttons to select the
required input method if needed. See “Switching
the input signal” on page 26.
The image will be projected on the screen.
1. Open the front panel cover.
2. Adjust the projected image with the lens shift lever.
See “Lens shift and positioning” on page 17.
3. Adjust the angle of the projector.
Screw down the front leg adjusters and adjust the
angle vertically.
See “Front leg adjusters and throwing angle” on
page 16.
4. Adjust the focus and the projected image size.
Turn the focus lever and zoom lever to adjust the
image.
You can confirm the adjusted effect with the TEST
PATTERN in OPTION menu. See “TEST PATTERN”
on page 43.
Selecting the input signal
NOTE:
• SIGNAL SEARCH is ON as default and the signal from
the connected devices is detected automatically. See
“SIGNAL SEARCH” on page 39.
Positioning the image
NOTE:
• Do not touch the air exhaust port as this may cause
burns or injury.
• If keystone distortion occurs, see “KEYSTONE” on
page 35.
• If you adjust the focus, you may need to adjust the size
of the image by moving the zoom lever again.
Focus lever
Zoom lever