Filter
Top Products
PROJECTOR SETUP menu
ENGLISH - 43
Settings
Q COMPUTER2
COM.AUDIO IN 2
Output audio that is input to the
COMPUTER AUDIO 2.
AUDIO IN Output audio that is input to the
AUDIO IN.
You can use the 7 different test patterns to adjust the
focus of the image. See “Lens shift and positioning” on
page 17.
1. Press the ENTER button to display the test pattern
1.
2. Press I H to select the required test pattern.
3. Adjust the focus with the focus lever.
4. Press the MENU or RETURN button to return to
the previous menu, or press repeatedly to escape
from the menu mode.
You can reset all of the customized settings to the factory
defaults except NETWORK, RUNTIME and
REMAINING FILTER of STATUS in PROJECTOR
SETUP menu.
1. Press the ENTER button.
2. Select OK by pressing I, then press the ENTER
button.
3. Turn off the power by pressing the power button.
4. Switch off the MAIN POWER button to reset the
projector.
5. Switch on the MAIN POWER button.
6. Press the power button.
7. The minimum required setting screen will be
displayed.
See “Minimum required setting screen” on page 11.
After you replaced the Auto Cleaning Filter (ACF),
REMAINING FILTER of STATUS in PROJECTOR
SETUP need to be reset to "0".
1. Press the ENTER button for more than 3 seconds.
The confirmation screen will be displayed.
2. Select OK by pressing I, then press the ENTER
button.
3. Display the STATUS and confirm the figure.
TEST PATTERN
NOTE:
• When the projector and/or the screen is tilted, adjust
the focus at the center of the image. The upper and
lower edge might be out of focus.
• When the image is distorted in keystone, adjust the
KEYSTONE in POSITION menu.
INITIALIZE ALL
NOTE:
• The security system is deactivated by default and when
initialized.
• When the projector is initialized, it will be reset to the
factory default password operation.
FILTER COUNTER RESET