Filter
Top Products
32
- ENGLISH
Basic Operation
Projecting
Check the connections of the peripheral devices and connection of the power cord (
Æ
page 27) and switch on the
power (
Æ
page 29) to start the projector. Select the image and adjust the state of the image.
Selecting the image
Select an input signal.
The image selected with the <COMPUTER 1>,
<COMPUTER 2>, <VIDEO>, <S-VIDEO>, or
<COMPONENT> button is projected (
Æ
page 33).
Attention
Images may not be projected properly depending on the
z
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
in [Component] or [RGB] in the [Input] menu (
Æ
page 39).
Check the aspect ratio of the screen and the image and
z
select the optimum aspect ratio under the [Screen] menu
(
Æ
page 48).
How to adjust the state of the
image
Adjust the projection angle.1 )
For details, see “Adjusting front adjustable foot”.
z
(
Æ
page 25)
Adjust the zoom and the focus.2 )
Turn [Zoom ring] and [Focus ring] to adjust the
image.
Note
It is recommended that the images are projected
z
continuously for at least 30 minutes before the focus is
adjusted.
If you adjust the focus, you may need to adjust the size
z
of the image by adjusting the zoom ring again.
If keystone distortion occurs, see “KEYSTONE”
z
(
Æ
page 49).
Focus Ring
Zoom Ring