Filter
Top Products
Setting
ENGLISH -
55
Settings
Note
When selecting [Network], the cooling fans may be
z
running depending on the temperature inside the
projector even if the projector is turned off.
Refer to "Operating Instructions - Network Operations
z
".
If [Standby mode] is set to [Eco], you cannot use network
z
functions when the projector is standing by. Also, you
cannot use some RS-232C protocol commands.
If set to [Network], you can use network functions when
z
the projector is standing by.
P-timer
This function allows you to change the setting of the
[P-timer] and execute it.
Press ▲▼ to select [P-timer].1 )
Press ► or <SELECT> button to 2 )
access the submenu.
Mode
J
Press ▲▼ button to select one mode 1 )
among the items as below.
Count up
The [P-timer] display 000:00
appears on the screen and the
count up starts (000:00-180:00).
Count down
The time set in the [Timer] setting
appears on the screen and the
countdown starts.
Timer
J
Press ▲▼ to select [Timer] and then 1 )
press the <SELECT> button.
Press▲▼ to set the [Timer](1-180 Min).2 )
Timer is available in [Count down] only. Factory
z
default value is 10 Min.
Execute
J
Press ▲▼ to select one among the 1 )
items as below and then press the
<SELECT> button.
Start
It executes the [count up] or [count
down] function.*
1
Reset
Reset the P-timer values.*
2
Exit
To exit the P-timer operation.
Press the <SELECT> button at [Start] and the *1 :
indication changes into [Stop]. To stop [Count up]
or [Count down], press the <SELECT> button at
[Stop] on the [screen] menu, then the indication
changes into [Restart]. Press the <SELECT>
button at [Restart] to resume [Count up] or [Count
down].
Press the <SELECT> button at [Reset] to return *2 :
to the following value:
Count up
"000:00"
Count down
Timer that you set
Attention
To stop the [P-timer] function, press the <P-TIMER>
z
button.
To cancel the [P-timer], press and hold the <P-TIMER>
z
button for a few seconds.
Closed caption
[
Only for NTSC, 480i input
]
Press ▲▼ to select [Closed caption].1 )
Press ► or the <SELECT> button to 2 )
enter the submenu.
Closed caption
J
Press ▲▼ to select [Closed caption] 1 )
and then press the <SELECT> button.
Press ▲▼ to select [Off], [CC1], [CC2], 2 )
[CC3] or [CC4].
Color
J
Press ▲▼ to select [Color] and then 1 )
press the <SELECT> button.
Press▲▼ to select color or white.2 )
Attention
The closed caption is mainly used in the north America.
z
This function shows the text information contained in the
image signal. Captions may not be displayed on some
devices or software.
You can select [Closed caption] when [NTSC] or [480i]
z
signals are input.
Part of characters may not displayed when high
z
compensation valued are set in [Keystone].
Closed captions are not displayed while the menu screen
z
appears.