Panasonic PT-RZ470UW Projector User Manual


 
Chapter 4Settings — [PICTURE] menu
ENGLISH - 53
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the
system method matching the input signal.
1) Press as to select [SYSTEM SELECTOR].
2) Press the <ENTER> button.
3) Press as to select a system format.
f Available system formats vary depending on the input signal.
Terminal System format
<VIDEO IN> terminal
Select [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL-M], [PAL-N], [SECAM], or [PAL60].
Set it to [AUTO] normally. (Setting [AUTO] will automatically select [NTSC], [NTSC4.43], [PAL],
[PAL-M], [PAL-N], [SECAM], or [PAL60].)
Switch the setting to the signal method for the TV used.
<COMPUTER IN> terminal,
<DVI-I IN> terminal
*1
480i, 576i, or 576p signal Select [RGB] or [YC
B
C
R
].
VGA60 or 480p signal Select [VGA60], [480p], or [480pRGB].
Other movie-based signals Select [RGB] or [YP
B
P
R
].
<DVI-I IN> terminal
*2
480p or 576p signal Select [RGB], [YC
B
C
R
444], or [YC
B
C
R
422].
Other movie-based signals Select [RGB], [YP
B
P
R
444], or [YP
B
P
R
422].
<HDMI IN> terminal
480p or 576p signal Select [AUTO], [RGB], [YC
B
C
R
444], or[YC
B
C
R
422].
Other movie-based signals Select [AUTO], [RGB], [YP
B
P
R
444], or[YP
B
P
R
422].
*1 When [DVI-I IN] is set to [ANALOG].
*2 When [DVI-I IN] is set to [DIGITAL].
4) Press the <ENTER> button.
Note
f Refer to “List of compatible signals” (x page 130) for the types of video signals that can be used with the projector.
f This may not function properly for some connected external devices.
sRGB-compliant video
sRGB is an international standard (IEC61966-2-1) for color reproduction dened by IEC (International Electrotechnical Commission).
Set the projector using the following procedures for more accurate color reproduction that complies with sRGB.
1) Set [COLOR MATCHING] adjustments to [OFF].
f Refer to [COLOR MATCHING] (x page 67).
2) Display the [PICTURE] menu.
f Refer to “[PICTURE] menu” (x page 49).
3) Press as to select [PICTURE MODE].
4) Press qw to set [NATURAL].
5) Press as to select [COLOR].
6) Press the <DEFAULT> button on the remote control to set factory default settings.
7) Follow Steps 5) to 6) to set factory default settings for [TINT] and [COLOR TEMPERATURE].
Note
f sRGB is available for RGB signal input only.