Filter
Top Products
Chapter 4 Settings — [PROJECTOR SETUP] menu
78 - ENGLISH
[ECO SAVE2]
Reduces the power by approximately 30 % in average compared to [NORMAL], minimizing reduction
in brightness.
[LOW] Sets this when you want to save more power without the need for high brightness.
Note
f The rate of power consumption reduction when the eco save mode is set refers to the ratio of average power consumption when a
“Broadcast” video signal that complies with IEC62087 is projected.
f When [ECO SAVE1] and [ECO SAVE2] is set, the image may appear differently to [NORMAL].
f If you feel that the brightness has decreased with [ECO SAVE2], switching to [ECO SAVE1] may improve the image.
f When [LOW] is set, the operating noise can be reduced.
f When the VIDEO input is selected, [ECO SAVE1] and [ECO SAVE2] cannot be selected. When [ECO SAVE1] or [ECO SAVE2] is set while
selecting other than VIDEO input, and when the VIDEO input is selected, [LOW] is set.
f When [NATURAL] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may not
conform to sRGB standards.
f When [REC709] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may not
conform to Rec.709 standards.
f When [DICOM SIM.] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may
appear different from the image of DICOM standards.
f Cannot be selected when viewing 3D videos. This is xed to [NORMAL].
Setting [AUTO POWER SAVE]
Set whether to enable the three functions [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], and [AV MUTE DETECTION].
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [AUTO POWER SAVE].
4) Press qw to switch [AUTO POWER SAVE].
f The items will switch each time you press the button.
[ON] Enables power-saving mode.
[OFF] Disables power-saving mode.
5) Press as to select [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], or [AV MUTE
DETECTION].
[AMBIENT LIGHT
DETECTION]
Adjusts the light source power depending on the brightness of the location of the projector.
[SIGNAL DETECTION] Reduces the power of the light source when there is no signal.
[AV MUTE DETECTION] Reduces the power of the light source in AV mute mode.
6) Press qw to switch the setting of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], or [AV MUTE
DETECTION].
f The items will switch each time you press the button.
[ON] Enables the setting.
[OFF] Disables the setting.
Note
f When [AUTO POWER SAVE] is [OFF], [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], and [AV MUTE DETECTION] cannot be
set.
f [AMBIENT LIGHT DETECTION] cannot be selected when viewing 3D videos. This is xed to [OFF].
Setting [NO SIGNAL SHUT-OFF]
A function that automatically switches the power source of the projector to standby if there is no input signal for a certain period of time. The
time before switching to standby can be set.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.