Filter
Top Products
24
You can make the setting for infrastructure mode
※
(connection through the access point
※
); however, confirm to your system
administrator on network settings before changing any settings.
※“Glossary” (See pages 70 - 71)
A Projector settings
1
Turn on the projector and press the [NETWORK] button on the remote control.
2
Press the menu button to open the [NETWORK] menu, and then select from among
[USER 1] through [USER 3] for [WIRELESS LAN] and press [ENTER].
3
Set the details of network and select [OK].
As for network setting items, see pages 53 - 55.
Confirm to your system administrator on network settings before changing any settings.
B Computer settings
4
Turn on the computer.
5
Make the network setting according to your system administrator.
6
Connect to your access point.
If no projector is displayed, click [ ] to start searching by IP address. (See page 29)
7
Start Wireless Manager ME 5.5.
A confirmation message appears asking whether to switch the projector to the network or not. Select [No].
8
Select a projector you want to connect on the <Projector Search> window ([S-MAP]
or [1-4/U]), and click [Connect]. (See pages 18, 19)
The launcher appears and the connection with the projector is established.
(“Descriptionofthelauncher”→
See page 32)
Connecting with wireless LAN (cont.)
The projector’s MAC address
※
can be checked with [STATUS] in the network menu of the projector unit.
(“Verifyingsettings”→
See page 59) ※“Glossary” (See page 70)
Connecting through the access point
If you cannot establish wireless LAN connection via an access point after performed the right steps described in “A Setting
projector”, contact the manufacturer of your access point (i.e. radio relay device).