Filter
Top Products
Starting the elite
Panaboard software and
Performing Calibration
1. Turn on the elite Panaboard.
2. Connect the elite Panaboard to your computer
with the USB cable.
• The elite Panaboard software starts
automatically.
• When you start the elite Panaboard software for
the first time, the calibration screen is displayed.
• Restart your computer if you are prompted to do
so. After the computer has restarted, connect
the elite Panaboard to your computer with the
USB cable.
3. Perform calibration.
4. Press the electronic pen at a right angle against
the board at the intersecting points of each
circle until it disappears (about 2 seconds).
Repeat in the order shown in the illustration
below.
AB
CD E
• Hold and press the electronic pen at a right
angle to the screen board.
• When you push down on the penpoint, the
electronic pen makes a buzzing sound.
• When the position of the indicated point has
been determined correctly, calibration
automatically moves to the next point.
• When calibration has finished normally, a
completion dialog box is displayed.
5. Click [OK].
• If the elite Panaboard and projector are fixed so
that they will not move (Wall mounted case),
select the [Always use this calibration
information.] check box, and click [OK] to skip
calibration from the next time you start the elite
Panaboard software.
Operating Instructions (For Basic Operations) 25
1
Usage