Filter
Top Products
47
[Host authentication]
Select "ON" or "OFF" to determine whether or not to
authenticate the host.
Default setting: OFF
Important:
Before selecting "ON" for "Host authentication", it is
necessary to register IP addresses of the PCs to be
allowed to access the unit and determine their
access levels.
[IP address]
Enter the IP address of the PC to be allowed to access
the unit.
Host name is unavailable for the IP address.
Default setting: (blank)
Notes:
• When "IP address/subnet mask" is entered, it is pos-
sible to restrict PCs in each subnet.
For example, when "192.168.0.1/1/24" is entered
and "2. Camera control" is selected for the access
level, the PCs whose IP address is between
"192.168.0.0" - "192.168.0.255" can access the
camera with the access level "2. Camera control".
• When the IP address already in use is entered and
the [SET] button is clicked, the respective host infor-
mation will be overwritten.
[Access level]
Select the access level of the host from the following.
1. Administrator/2. Camera control/3. Live only
Refer to page 46 for further information about the
access level.
Default setting: 3. Live only
Note:
By clicking [i] of "Host check", the registered host
can be selected and the selected host’s IP address
can be checked.
The registered IP address will be displayed with the
access level. (Example: 192.168.0.21 [1])
To delete the registered host, click the [DEL] button
after selecting the IP address to be deleted.
Configure the settings relating to the host authentication [Host]
Click the [Host] tab on the "Authentication setup" page. (☞ page 46)
The settings to restrict PCs (IP address) to access the unit can be configured on this page.