Filter
Top Products
4
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
wq e r t y u
Video Monitor WV-CM
MENU
AUDIO
PO WE R STANDBY
INPUT
SELECT
ON
OFF
q Power Button (POWER ON/OFF)
This button turns the power of the monitor on and off.
w Power Indicator
Is on when the power of the monitor is turned on, also
in standby mode.
On: Green light
Standby: Orange light
e Standby Button (STANDBY)
Pressing this button toggles the display mode on the
monitor screen as shown below.
On: Normal display
Standby (MODE 1): Lower display brightness
Standby (MODE 2): No display (blackout)
r Input Selection Button (INPUT SELECT)
Selects input in the sequence shown below.
t Menu Button (MENU)
Pressing this button opens the Display Setting menu for
changing the monitor’s display settings.
y Direction Button (C, D)
These buttons move the cursor to the item parameters
in the Display Setting and Setup menus.
C: Down
D: Up
● Front View
!8
!4 !5!3!1 !2 !6!7
OUT
G
FOCUS
OUT
VIDEO
OUT AC IN
B
IN
A
IN
STANDBY
ON
STANDBY
OFF
AUDIO
IN
● Rear View
u Decrement/Increment Button (AUDIO -, +)
Press these buttons to increase or decrease the audio
volume.
These buttons also select the item parameter or level in
the Display Setting and Setup menu.
!1 Focus Control (FOCUS)
This control adjusts the screen focus.
!2 Screen Control
This control is preset at the factory.
!3 Standby Control Terminal (STANDBY ON/STANDBY
OFF/G)
This terminal accepts input from an outboard device to
control the standby mode.
It operates as follows:
STANDBY ON: Establishes the specified standby
mode.
STANDBY OFF: Releases standby mode (normal dis-
play).
!4 Audio Input Connector (AUDIO IN)
For audio input from an outboard device
!5 Audio Output Connector (AUDIO OUT)
The audio input signal connected to the Audio Input
Connector is looped through to this connector.
VIDEO IN A VIDEO IN B