Filter
Top Products
1740 SHDSL 2/4-Wire Router User’s Guide
CHAPTER 7 Routing
This chapter describes how to set up the static routes and RIP. Click Routing Setup from the Basic menu
bar to configure the routing functions.
7.1 Static Route
The Static Route Configuration field allows you to add, modify, and delete a static route. Type the
Destination Network ID, subnet mask, and next hop IP and click a button below to perform the requested
function.
The router has no default static route. After an RFC 1483-routed VC is created, a static route as follows
will be created.
Network ID Subnet Mask Next Hop IP
0.0.0.0 0.0.0.0 10.0.0.2
Click Routing Setup on the Basic menu bar to access the Routing Setup window. It allows adding,
modifying, and deleting the static routes.
Add:
To add a static route complete the following steps:
STEP 1: Enter the parameters for Destination Network ID, Subnet Mask, Next Hop IP
STEP 2: Click on the ADD button
Modify:
To modify a static route complete the following steps:
STEP 1: Select the entry you wish to modify from the List of Static Routes
STEP 2: Change the parameters
STEP 3: Click on the Modify button
1740-A2-GB20-00 July 2004 39