Filter
Top Products
4. Configuration
4-4 June 2004 2600-A2-GN20-20
BitStorm 2600 Startup Procedure
You can initialize your BitStorm 2600 via a PC or terminal connected to the unit’s
CONSOLE port. Then, using a series of CLI commands, GrandVIEW EMS or
another Element Management System, or the web interface, you can configure the
unit according to your requirements.
Login
Procedure
To log in to the BitStorm 2600:
1. Connect a PC or terminal to the CONSOLE port. (See Console Port in
Chapter 2, Cabling.)
2. At the login> prompt, type admin and press Enter.
3. At the password> prompt, press Enter. The default login password is blank.
4. At the PDYN> prompt, type privilege and press Enter.
5. At the password# prompt, press Enter. The default privileged password is
blank.
You are now logged on and in privileged mode, which allows you to configure the
unit.
Management Modes
The startup procedure for the BitStorm 2600 system differs depending on the type
of management used:
Inband Management – Operates over the uplink.
Out-of-Band Management – Operates over Port 1.