Filter
Top Products
WR1500 4-Port Wireless DSL/Cable Router
®
17
Next, you will need to change the IP Address.
Step 1. On the LAN screen, change the IP Pool Starting Address (Box 1 on the illustration
below; 192.168.1.33 by default) to the recommended setting of 192.168.2.33.
Step 2. Change the IP Address (Box 2 on the illustration below; set to 192.168.1.1 by
default) to the recommended setting of 192.168.2.1.
Step 3. Click Apply at the bottom of the screen to save the settings. Clicking Apply will
cause you to lose your connection to the Web Confi guration Utility.
Step 4. Turn off power to both the WR1500 and cable/DSL modem.
Reconnecting the cable/DSL modem
Step 1. While both are powered off, reconnect the cable/DSL modem to the WAN port on the
WR1500. (see Step 1 and Step 2 in the WR1500 Quick Start Guide).
Step 2. Power the router back on, wait until the status lights are normal.
Step 3. Power the cable/DSL modem.
After you have performed these steps you should reboot the computer and test
the LAN/WAN connectivity. If you are still having issues, ParkerVision Technical
Support is available at 800.231.1759 or at support@parkervision.com.
Apply Reset
DHCP Setup
LAN TCP/IP
Windows Networking (NetBIOS over TCP/IP)
DHCP Server
IP Pool Starting Address
192.168.1.33
Pool Size
8
DNS Servers Assigned by DHCP Server
First DNS Server
Second DNS Server
Third DNS Server
From ISP
0.0.0.0
0.0.0.0
0.0.0.0
IP Address
IP Subnet Mask
Multicast
192.168.2.1
255.255.255.0
None
Allow between LAN and WAN
LAN
1
2
From ISP
From ISP
RIP Direction
RIP Version
Both
RIP-1
IP