Filter
Top Products
8
4.0 INSTALLATION
The 2124/2130 is equipped with Network, DTE, and power interfaces.
This section briefly describes connnection to each interface.
4.1 CONNECT TO 10BASET ETHERNET PORT
The shielded RJ-45 Ethernet port on the Model 2124/2130 is designed to
connect directly to a 10BaseT network. Figure 3 shows the 10BaseT RJ-
45 port pin description. You may make connections up to 300 feet using
type 4 or 5 cable.
Figure 3.
Model 2124/2130 Ethernet connector pinout
Connect the 10BaseT Ethernet Port to a Hub
The Model 2124/2130 10BaseT interface is configured as DTE (Data
Terminal Equipment). Use the diagram below to construct a cable to con-
nect the 2124/2130 to a 10BaseT Hub.
Connect the 10BaseT Ethernet Port to a PC (DTE)
The Model 2124/2130 10BaseT interface is configured as DTE (Data
Terminal Equipment). To connect the 2124/2130 to another DTE such as
a 10BaseT network interface card in a PC, construct a 10BaseT cross-
over cable as shown in the diagram below.