Patton electronic 3008/I Modem User Manual


 
2
Model 3088/I Quick Start Guide
1.0 Power up the NTU
Your NTU comes with an external AC adaptor with detachable power cord.
1.1 AC power-up
1.
Connect female plug of the AC power cord to the AC adaptor provided.
2.
Connect the barrel-type connector of the AC adaptor to the barrel-type power jack on the
RocketLink-G NTU.
3.
Insert the male plug of the AC power cord into an AC power outlet (100–240 VAC)
.
1.2 DC power-up
The 36-60 VDC DC to DC adapter is supplied with the DC version of the Model 3088/I. The black and red leads
plug into a DC source (nominal 48VDC) and the barrel power connector plugs into the barrel power supply jack
on the 3088/I. (See
figure 1
).
This device contains no user serviceable parts. The equipment
shall be returned to Patton Electronics for repairs, or repaired
by qualified service personnel.
The external power adapter shall be a listed Limited Power
Source. The mains outlet that is utilized to power the devise
shall be within 10 feet (3 meters) of the device, shall be easily
accessible, and protected by a circuit breaker.
If an AC power adapter is used, ensure that the power cable
used meets all applicable standards for the country in which it
is to be installed, and that it is connected to a wall outlet which
has earth ground.
Hazardous network voltages are present in WAN ports regard-
less of whether power to the unit is ON or OFF. To avoid electric
shock, use caution when near WAN ports. When detaching the
cables, detach the end away from the device first.
Do not work on the system or connect or disconnect cables
during periods of lightning activity.
The interconnecting cables shall be acceptable for external use and shall be rated for
the proper application with respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
WARNING
CAUTION