4
Model 3088/I Quick Start Guide
2.
Start a HyperTerminal session on the PC using the settings:
9600 bps, 8 data bits, no parity, 1 stop bit, no flow control
3.
Log in to the RocketLink-G NTU using the factory-default login (
superuser
) and password (
superuser
):
Login:
superuser
Password: *********
Login successful
2.2 Modify the IP address
1.
Display current IP interface settings for the RocketLink-G
Ethernet
LAN port.
→→
→→
ip list interfaces <enter>
IP Interfaces:
ID | Name | IP Address | DHCP | Transport
---|------|----------------|----------|--------------
1 | ip1 | 192.168.200.10 | disabled | <BRIDGE>
----------------------------------------------
------
2.
Modify the IP address for the LAN port according to your network requirements.
→→
→→
ip set interface ip1 ipaddress 10.10.4.10 255.255.255.0
Note
The above IP address (
10.10.4.10/24)
is only an example. You must choose an IP address on the same
subnet as your PC
.
3.
Verify the new address is correct and save it in system boot memory.
→→
→→
ip list interfaces <enter>
→→
→→
system config save <enter>
→→
→→