Filter
Top Products
10
About this guide
This guide describes installing and operating the Patton Electronics Model 3088A G.SHDSL
OnSite™ CPE.
Audience
This guide is intended for the following users:
• Operators
• Installers
• Maintenance technicians
Structure
This guide contains the following chapters and appendices:
• Chapter 1 on page 14 provides information about CPE features and capabilities
• Chapter 2 on page 18 contains an overview describing CPE operation and applications
• Chapter 3 on page 34 provides hardware installation procedures
• Chapter 4 on page 41 provides quick-start procedures for configuring the OnSite CPE
• Chapter 5 on page 45 describes how to install and operate the OnSite CPE
• Chapter 6 on page 49 describes how to configure the OnSite CPE, save the configuration, reset the CPE to
the factory default condition, and upgrade the system software
• Chapter 7 on page 51 describes the system tools that can be used to diagnose problems with the CPE
• Chapter 8 on page 53 contains information on contacting Patton technical support for assistance
• Appendix A on page 56 contains compliance information for the OnSite CPE
• Appendix B on page 58 contains specifications for the CPE
• Appendix C on page 63 provides the factory default values for the CPE
• Appendix D on page 66 provides cable recommendations
• Appendix E on page 68 describes the CPE’s ports and pin-outs
For best results, read the contents of this guide before you install the CPE.