Filter
Top Products
Introduction 44
SN-DTA User Manual C • Cabling
Introduction
This section provides information on the cables used to connect the SN-DTA and the interface cards to the
existing network infrastructure and to third party products.
Ethernet
Ethernet devices (10Base-T/100Base-T) are connected to the SN-DTA over a cable with RJ-45 plugs. All
Ethernet ports on the SN-DTA are Auto-MDX and use any straight or crossover cable to connect to hubs,
switches, PCs or other devices.
Figure 10. Typical Ethernet straight-through cable diagram
Hub
RJ-45, male
1
2
3
6
RJ-45, male
1
2
3
6
Straight-through cable
Note: Other pins are not used.
E
T
H
0
/0
Reset
12
V D
C 1A
L
A
N
N
T
N
T
B
R
I 0
/0
B
R
I 0
/1