Filter
Top Products
4-2 Cleaning
6. Clean the platen roller with a dry cloth or small brush.
You can also use another cotton swab moistened with
isopropyl alcohol. Turn the platen roller with your
finger and run the cotton swab or dry cloth across it.
Make sure the platen roller is clean all the way
around.
7. Moisten another cotton swab with isopropyl alcohol.
Rub the cotton swab across the supply sensor to
remove any build-up.
8. Moisten another cotton swab with isopropyl alcohol.
Rub the cotton swab across the tear bar to remove
any build-up.
9. Use a can of compressed air to remove any debris
from the supply well.
10. Reload the supply roll.
11. Turn on the printer.
Supply
sensor
Platen Roller
Tear Bar