Filter
Top Products
4
5. Adjust the supply holder guides so the sides barely touch the roll. Make sure
the supply roll turns freely. If you are using fan-fold supplies, place the
supply stack behind the printer, label side facing up.
6. Push down on the supply lever to unlock the supply guides.
7. Lay the label strip across the supply guide so that a few inches extend past the
front of the printer. Tuck the supply under the nibs and in between the die cut
sensor.
For fan-fold supplies, lay the label strip over the supply holder and
across the supply guide so that a few inches extend past the front of the
printer. Tuck the supply under the nibs and in between the die cut sensor.
8. Adjust the supply guides so they touch the supply. Push up on the supply lever
to lock the supply guides into place.
Supply
Holder
Guides
Nibs
Die Cut Sensor
Supply
Lever