Filter
Top Products
5
9. Hold the printhead assembly by the printhead tab while pressing down on the
printhead release.
10. Close the printhead by pressing down on the thumb well until you hear it click
into place.
11. Close the cover.
12. Press Feed/Cut to position the supply under the printhead.
Loading Labels for the Optional Peel Mode
Peel mode must be purchased separately. In peel mode, the printer separates the
backing paper from the label. The next label is not printed until the completed one
is removed from the printer. Make sure the printer is configured for on-demand
mode and the correct supply type. The minimum feed length is 1.5 inches for peel
mode. Hold the leading edge of peeled labels when printing on stock longer than
six inches. You must use non-perforated supplies for peel mode. Follow the steps
for loading supplies from the previous section. Then, follow these steps after you
close the printhead.
1. Remove the labels from the first 10 inches of the backing paper.
2. Press down on the exit cover tabs to open the exit cover on the front of the
printer.