Filter
Top Products
Event Logs
48
Link X CSU/DSU: Loopback Started
Generated when the CSU/DSU link module starts a new loopback test.
Link X - CSU/DSU out of service
Generated when the CSU/DSU is in communication with the local telco, but is not connected to the remote
partner CSU/DSU.
Link X CSU/DSU: No Signal
Generated when the CSU/DSU link module cannot establish communications with the local telco.
Link X CSU/DSU: Reset
Generated when the P2600 has initiated a reset of the CSU/DSU link module.
Link X - external loopback results[Total: X] [Good: X] [Errors: X]
Generated after the CSU/DSU link module has completed an external loopback.
Link X - CSU/DSU CSU telco loopback started
Generated when the telco has initiated a CSU loopback to this CSU/DSU link module
Link X - CSU/DSU CSU telco loopback ended
Generated when the telco has terminated the CSU loopback to this CSU/DSU link module
Link X - CSU/DSU DSU telco loopback started
Generated when the telco has initiated a DSU loopback to this CSU/DSU link module
Link X - CSU/DSU DSU telco loopback ended
Generated when the telco has terminated the DSU loopback to this CSU/DSU link module
Link X – LMI Error Threshold exceeded.
Generated when the number of LMI enquiry errors exceeds the user-defined limit.
LMI discarding STATUS on link X – Enquiries not started
Generated when the bridge/router discards a Status message received from the frame relay network on a link
that the bridge/router has not yet started the Local Management Interface.
No NCP's open, tearing link down
Generated when a PPP link does not have a Network Control Protocol operating. This may be due to BCP,
IPCP, and IPXCP being disabled, or the NCP connection was not negotiated to completion.
Password accepted from <IP address>
Generated when a correct password is given for a Telnet connection. The connected Bridge/Router’s name
or IP address is specified.