Filter
Top Products
Geometry Controls window
Pincushion, Balanced
Pincushion, Balanced
Pincushion,
Pincushion,
T
T
r
r
apezoid,
apezoid,
P
P
ar
ar
allelogr
allelogr
am,
am,
R
R
ot
ot
a
a
tion
tion
Follow the steps below to adjust any of the five preset options (PINCUSHION, BALANCED PINCUSHION, TRAPEZOID,
P
ARALLELOGRAM, or ROTATION). You can make individual adjustments to each of the preset options.
Note: use these
features only when the picture is not square.
Smart Help
To exit GEOMETRY CONTROLS . . .
. .. but continue to another window,
turn the ROTARY knob until required function is highlighted. Now, press the ON SCREEN DISPLAY button and follow the
instructions for that window.
. . .TO exit completely,
press the ON SCREEN DISPLAY button and hold for 1.5 seconds.The On Screen Display will disappear.All changes will be saved.
To make changes to one item, follow the steps for that item. Then, follow
“
To exit GEOMETRY CONTROLS . .. .”
To return to factory presets, see “To Reset an Individual Window” on page 16.
Press the ON SCREEN
DISPLAY button.
2b
2b
1
1
2a
2a
Turn the ROTARY knob, if necessary, turn
the R
OTARY knob until PINCUSHION icon is
highlighted.
Press the ON
SCREEN DISPLAY
button.Then, turn
the R
OTARY knob to
adjust the
pincushion.
To select BALANCED
PINCUSHION, turn the
R
OTARY knob until
B
ALANCED PINCUSHION
is highlighted. Next,
press the O
N SCREEN
DISPLAY button.
4b
4b
Turn the ROTARY knob to
adjust the trapezoid.
4c
4c
5a
5a
5c
5c
When done, press
the O
N SCREEN
DISPLAY button to
save the change
and return to
G
EOMETRY CONTROLS
window.
5b
5b
How to Use the On Screen Display (OSD)
8
2c
2c
3a
3a
Turn the ROTARY
knob (on the
lower right-hand
corner of the
monitor) to adjust
the balanced
pincushion.
3b
3b
3c
3c
When done,
press the O
N
SCREEN DISPLAY
button.This will
save the change
and return the
screen to
G
EOMETRY
CONTROLS.
To select TRAPEZOID,
turn the R
OTARY
knob until TRAPEZOID
I
con is highlighted.
Next, press the O
N
SCREEN DISPLAY
button.
4a
4a
When done, press the
O
N SCREEN DISPLAY button.
This will save the
change and return the
screen to G
EOMETRY
CONTROLS window.
To select PARALLELOGRAM or
R
OTATION, turn the ROTARY knob
until P
ARALLELOGRAM or ROTATION
icon is highlighted. Next,
press the O
N SCREEN DISPLAY
button.Then follow steps 4b
and 4c to make the
appropriate changes.