Philips 200p7 Computer Monitor User Manual


 
Safety and Troubleshooting Information
Maintenance:
To protect your display from possible damage, do not put excessive pressure on the LCD
panel. When moving your monitor, grasp the frame to lift; do not lift the monitor by
placing your hand or fingers on the LCD panel.
Unplug the monitor if you are not going to use it for an extensive period of time.
Unplug the monitor if you need to clean it with a slightly damp cloth. The screen may be
wiped with a dry cloth when the power is off. However, never use organic solvent, such
as, alcohol, or ammonia-based liquids to clean your monitor.
To avoid the risk of shock or permanent damage to the set, do not expose the monitor to
dust, rain, water, or excessive moisture environment.
If your monitor gets wet, wipe it with dry cloth as soon as possible.
If foreign substance or water gets in your monitor, please turn the power off immediately
and disconnect the power cord. Then, remove the foreign substance or water, and send
it to the maintenance center.
Do not store or use the LCD monitor in locations exposed to heat, direct sunlight or
extreme cold.
In order to maintain the best performance of your monitor and use it for a longer lifetime,
please use the monitor in a location that falls within the following temperature and
humidity ranges.
Temperature: 5-35°C 41-95°F
Humidity: 20-80% RH
Service:
The casing cover should be opened only by qualified service personnel.
If there is any need for any document for repair or integration, please contact with your
local service center. (please refer to the chapter of "Consumer Information Center")
For transportation information, please refer to "Physical Specifications".
Do not leave your monitor in a car/trunk under direct sun light.
Consult a service technician if the monitor does not operate normally, or you are not
sure what procedure to take when the operating instructions given in this manual
have been followed.
A high contrast static image that remains on an LCD monitor screen for an extended
period of time may cause image retention, burn-in image or 'ghost' image on an
LCD monitor screen. This well-known phenomenon is caused by the inherent
technological limitations of LCD manufacturing. Always activate a screensaver
program to protect your display from image retention.
Warning: Failure to adhere to the given instructions may result in Image
retention or Burn in of Image, which is not repairable or removable. This
phenomenon is not covered under Philips warranty.
RETURN TO TOP OF THE PAGE
file:///D|/My%20Documents/dfu/200P7/english/200p7/safety/safety.htm (2 of 3)2006-12-11 1:16:15 PM