Filter
Top Products
4. Remove the SmartCard slot cap from the display by removing the two screws circled below.
Keep the screws for use in step 8.
5. Remove the hex nuts from the high-rise 15-pin D-SUB connectors as shown below with a
5mm nut driver tool. Keep the hex nuts for use in step 6.
high-rise
DB 15
connectors
6. Place the LT card cap over the LT card as shown below. Secure the card cap by re-fastening
the hex nuts onto the high-rise 15-pin D-SUB connectors.
Page 4 of 9 LT Installation Guide 1.1 (140907)
12NC: 3139 125 39281