Filter
Top Products
2
3
This chapter guides you through the installation of
your new CD-ROM drive. To install the drive, your PC
must have a free IDE interface connector, or you must
buy an IDE controller card from a computer retailer.
(An Enhanced IDE controller card is required if your
PC already has a one-port IDE controller). See
Appendix A
for a brief introduction to IDE
connections.
2.1 Installing the CD-ROM Drive
Here’s how to install your CD-ROM drive:
1.
Turn off your PC and remove its casing.
2.
Adjust the Master/Slave jumpers on the back of the
CD-ROM drive as necessary. (The factory default
of the slave mode normally should not be changed.
See
Appendix A
.)
3.
Remove the 5.25” drive’s drive guard as instructed
by your PC manual.
4.
Slide the CD-ROM drive into the drive bay.
INSTALLING YOUR
DRIVE
2