Filter
Top Products
8. OPERATION Other settings
Automatic Power Shutoff Function
When no input signal is detected for more than 15 minutes,
the projector will automatically shut off. The on-screen
message on the left will appear five minutes before the power
is automatically turned off.
Interlaced (I)/Progressive (P) conversion
This function allows you to select either an interlaced display or
a progressive display of a video signal. The progressive display
projects a smooth video image.
1.
Press Menu.
2.
Press 1 / 2 to select “Options”.
3.
Press 3 / 4 to select “I/P Conversion”, and then press 2.
4.
Press 3 / 4 to select “Interlaced” or “Progressive”.
5.
Press OK to save the setting.
6.
To exit from the GUI, press Menu.
Checking the Lamp Usage Time
This function allows you to check the accumulated lamp usage
time.
1.
Press Menu.
2.
Press 1 / 2 to select “Options”. The lamp usage time will
be displayed.
– It is recommended that the lamp be replaced after
approximately 2,000 hours of usage. See page 25 for
details.
Selecting signal type (Data 1 only)
This function allows you to select the input signal type.
1.
Press Menu.
2.
Press 1 / 2 to select “Options”.
3.
Press 3 / 4 to select “Signal Type”, and then press 2.
4.
Press 3 / 4 to select “Computer/RGB” or “Component”.
5.
Press OK to save the setting.
6.
To exit from the GUI, press Menu.
Checking the Input Signal
1.
Press Menu.
2.
Press 1 / 2 to select “Options”.
3.
Press 3 / 4 to select “Signal Info” to display the current
input signal.
4.
To exit from the GUI, press Menu.
Note:
In Video mode, the resolution and frequency settings will not
be displayed. This function allows you to check the current
input signal information.
23
English