Filter
Top Products
Philips Semiconductors
UM10014_4
ISP1520 Hi-Speed USB Hub Demo Board
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
User manual Rev. 04.00 — 11 May 2004 17 of 18
7. Installing the Board
Assuming that you have already installed the USB host adapter (including drivers) on a computer
running Windows, installing the hub is fairly simple.
1. Plug in power from the power supply to the hub. The power supply must meet the
requirements specified in Section 4.
2. Plug a USB cable in the USB0 port, and connect the other end of the cable to the USB host.
After a while the GoodLink LED (D15) will start to blink. This indicates that the
enumeration process has successfully completed and the hub is now ready for use.
You can check the driver installation in the Device Manager window. To check whether the hub
is correctly installed in high-speed, select the View-Devices by connection command in the
Device Manager window.
3. Plug in devices at the downstream facing ports.