Filter
Top Products
8
En
Drive
Lock lever
Guide rails
1. When inserting a drive, be sure to
place the drive on the changer guide
rails and push the drive in until the
lock lever on the drive shifts to the
locked position. Maybe you can hear
a clicking sound then.
When a drive is to be removed from the
changer, flip the lock lever to the released
position and then pull the drive out from the
changer.
A HARDWARE TOUR
0
TOP VIEW
0 Function switch
TO INSTALL THE DRIVE
For instructions on how to open the access
doors, see the operating instructions for the
DRM-7000 disc changer.
Before installation, be sure to specify the
following settings at the rear of each drive
to be installed.
¶ SCSI ID assignment
Specify the SCSI IDs to be used so as
to ensure that the same SCSI ID is not
assigned by more than one drive on the
same SCSI bus.
¶ Termination
Set the termination switch of the last
drive in the SCSI chain to the ON
position.
Warning about static electricity
Always be sure never to touch the
contacts or ports when operating
drives.
Also be sure to touch a metallic surface
on the changer before installing
additional drives to the changer.
This switch is used to check the
device before shipment, and its
setting should never be changed.
¶ Set OFF at the time of shipping from the plant.
ON OFF