Filter
Top Products
10
En
Safety Precautions
02
Installation using the optional PIONEER stand or
installation bracket
• Please be sure to request installation or mounting of this
unit or the installation bracket by an installation specialist or
the dealer where purchased.
• When installing, be sure to use the bolts provided with the
stand or installation bracket.
• For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
IInstallation using accessories other than the
PIONEER stand or installation bracket (sold
separately)
• When possible, please install using parts and accessories
manufactured by PIONEER. PIONEER will not be held
responsible for accident or damage caused by the use of
parts and accessories manufactured by other companies.
• For custom installation, please consult the dealer where the
unit was purchased, or a qualified installer.
Wall-mount installation of the unit
This unit has been designed with bolt holes for wall-mount
installation, etc. The installation holes provided are shown in
the accompanying illustration.
• Be sure to attach in 4 or more locations above and below, left
and right of the center line.
• Use bolts that are long enough to be inserted 12 mm to 18
mm (1/2 in. to 11/16 in.) into the main unit from the attaching
surface. Refer to the side view diagram in the accompanying
illustration.
• As this unit is constructed with glass, be sure to install it on
a flat, unwarped surface.
CAUTION
To avoid malfunction, overheating of this unit, and possible fire
hazard, make sure that the vents on the main unit are not
blocked when installing. Also, as hot air is expelled from the air
vents, be careful of deterioration and dirt build up on rear
surface wall, etc.
CAUTION
Please be sure to use an M8 (Pitch = 1.25 mm) (1/16 in.) bolt.
(Only this size bolt can be used.)
CAUTION
This unit incorporates a thin design. To ensure safety if vibrated
or shaken, please be sure to take measures to prevent the unit
from tipping over.