Pitney Bowes B700 Postal Equipment User Manual


 
Page 8
B700 Installation Instructions
6. Install the Stacker
Slide the stacker up against the
right side of the meter and posi-
tion it as shown. The stacker sits
next to the meter. It's not physi-
cally connected to it. In this posi-
tion, the stacker can handle enve-
lopes up to #10. If you're using
longer envelopes, move the stacker
to the right to accommodate
them.
7. Make a Test Imprint
a. The display normally shows the default postage amount
shown at the right. This is usually the rate for first class
letter mail weighing up to one ounce.
b. At the keyboard type a
0 (zero) and then Enter.
c. The display now shows zero as the postage value. The
meter is ready to use when the amount you entered is
bracketed by three bars as shown.
d. Place a sample
envelope on the
feed deck
face
up and push it
against the rear
wall of the meter
(1).
e. Slide the enve-
lope to the right
(2) until its lead
edge touches the
trip mark on the
feed deck.
f. The meter will
sense the pres-
ence of the envelope, convey it through the print area and into the stacker. The meter
impression should look similar—but not necessarily identical—to that shown in the
figure at the top of the next page.
Push Envelope up
to Mark on Deck
1
2
Insert Envelope
from Left
B700 Installation 8/18 REV A 05/13/97, 1:17 PM8