Pitney Bowes B700 Postal Equipment User Manual


 
B700 Installation Instructions
Page 7
h. Data Center: “The setting/combination
number is __________.”
i. Data Center: “Please enter request code.”
j. Data Center: “Setting number is:______
__________.”
k. Data Center: “Please enter request code.”
Write this number in the space provided
on your refill report.
At the telephone press 7 followed by the
* (asterisk) to hear the setting/combina-
tion number again.
Press 4 and * to end the call.
Make sure the setting/combo number you
wrote in step h is correct.
Completing the Refill at Your Meter
a. The meter prompts: “Enter Combo.”
b. Use the meter's number keys to type the setting/combination number the Data Center
gave you in step h above. Press Enter.
c. If the refill is successful, the display briefly shows “Refill OK” and then “$Avail= XXX.XX”
where XXX.XX is the postage amount now available. (If the refill amount you asked for
was $50.00 or less, the meter displays “Low Funds.” This is normal. As delivered, your
meter is set to show this warning when the postage available reaches or falls below $50.00.)
d. If the refill was not successful, the display will show “Failed” for two seconds and then
“Insuf Funds.” If this happens, or should you have other problems with your meter after
following the steps in this installation guide, please call:
Direct Distribution Assistance
1-800-562-8237
The Direct Distribution Help Line is available Monday through Friday between the hours of
8:00 A.M. and 8:00 P.M., Eastern Standard Time.
Congratulations! Your meter is now installed, filled with post-
age and ready to go to work for you. The instructions on the
next two pages tell you how to process mail. If your meter is
equipped with the optional Electronic Interface (DataLink) fea-
ture, follow the setup and operating instructions furnished with
it. See page 11 of this booklet.
B700 Installation 8/18 REV A 05/13/97, 1:17 PM7