Filter
Top Products
Page 2
B700 Installation Instructions
2. Connect the Power Cord
Remove the meter from its carrying case and place
it on your work surface, close to a properly grounded
120 VAC wall outlet. Choose a convenient loca-
tion—one where you have enough room to estab-
lish an efficient work flow.
a. Connect the power cord to the receptacle at the
back of the meter as shown.
b. Connect the power cord to a properly grounded
120 VAC wall outlet.
WARNING: Always plug the
meter into a properly grounded wall outlet. This reduces the risk of shock and
equipment damage in the event of a short circuit. DO NOT remove the power
cord’s ground pin and DO NOT use a ground adapter. Read the safety notes
printed on the inside front cover of this booklet.
A
B
3. Install the Ribbon
a. Unpack the ribbon cassette and
remove the shipping tab. If nec-
essary, turn the winder counter-
clockwise to remove any slack
from the ribbon.
b. Open the cassette door.
U
L
B700 Installation 8/18 REV A 05/13/97, 1:16 PM2