Filter
Top Products
Page 84
Windows 2000, XP and Server 2003
1. Start the Add Printer Wizard, select Network Printer, then click Next to browse for
the Print Server.
2. Locate and double-click the Print Server, select the desired port, and click Next.
The following message will be displayed:
Figure 26: Windows 2000 Message
3. Click "OK", and select the correct Manufacturer and Model for this printer.
4. Follow the prompts to complete the installation.
5. In the Printers folder, right-click the new printer, and select Sharing.
• Select "Shared As:" and enter an appropriate name for this printer. Users will
see this name when browsing for the printer during installation.
• If desired, click "Additional Drivers" and install printer drivers for other versions
of Windows, such as Windows 98. This will assist users during the installation
process.
6. Click OK to close this Window. Configuration is now complete.
Client PCs can now be configured as described in Chapter 4 - Client Configuration.
Novell NetWare
The FPS-5P-M/FPS-5P-S are fully support both Bindery and NDS Novell systems.
With either Bindery or NDS, two (2) NetWare operating modes are possible - Print
Server and Remote Printer. Print Server mode is recommended.
Novell Distributed Printing Services (NDPS) under NetWare 5 is also supported.
Configuration Methods (Bindery or NDS)
The following configuration methods are available. In each case, you must be logged
into the required NetWare Server with ADMIN rights.
Also, if using Windows, Novell's Client32 should be installed on your PC. Without Cli-
ent32, only limited configuration changes can be made on the NetWare Server.
Setup Wizard
Using the Setup Wizard is recommended. This allows configuration of the Print Server
in NetWare Print Server Mode, which is the recommended system.