Filter
Top Products
15
Network settings via Keypad commands
The ATA series phone adapters support telephone keypad configurations, please connect analog
telephone set and refer to the following table for machine network configurations.
IVR Menu Choice Machine operation Parameter(s) Notes:
#111#
Set DHCP client None
ATA will change to DHCP
Client
#112xxx*xxx*xxx*
xxx#
Setup Static IP Address
Use the * (star) key
when entering a decimal
point.
DHCP will be disabled and
system will change to the
Static IP type.
#113xxx*xxx*xxx*
xxx#
Set Network Mask
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#114xxx*xxx*xxx*
xxx#
Set Gateway IP Address
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#115xxx*xxx*xxx*
xxx#
Set Primary DNS Server
Use the * (star) key
when entering a decimal
point.
Must set Static IP first.
#136#
Enable auto-config mode None
For PLANET IPX -2000 IP
PBX System
#137#
Disable auto-config mode None
For PLANET IPX -2000 IP
PBX System
#195#
Reboot None
The system will reboot
automatically.
#198#
Factory Reset None
The system will be reset to
factory default value and
reboot automatically.
＊
To switch IP Phone mode None VIP-157 only
Following keypad commands can be used to display the network settings enabled on ATA via voice
prompt.
IVR Menu Choice Machine operation Notes:
#120#
Check IP Address
IVR will announce the current IP address of
the ATA.
#121#
Check network connection Type
IVR will announce if DHCP in enabled or
disabled.
#122#
Check the Phone Number
IVR will announce current enabled VoIP
number.