Filter
Top Products
Device configurations on the ATA:
STEP 5:
Please log in ATA via web browser, browse to the SIP setting menu and select the Domain
Service config menu. In the setting page, please browse to the Auto-config page, and
enable the Auto Configuration features for IP PBX system. (Your may connect telephone set
to ATA, press #136 to enable the Auto configuration, or press #137 to disable the Auto
Configuration setting.)
STEP 6:
After enabling the auto-config feature, the ATA shall be able to obtain IP address and SIP
extension information from IP PBX system IPX-2000 information. To verify the auto-config
results, you may connect telephone set to ATA; press #120# to check if the IP address is
obtained from IPX-2000. And #122# can be used to verify the extension number assigned by
IPX-2000.
STEP 7:
Repeat the same configuration steps on ATA B, and check if the ATA B is successfully
registered with the IPX-2000 as one of the IP extensions.
Test the scenario:
To verify the VoIP communication, please:
1. Pick up the telephone
2. [VIP-157 only] Press the “*” key to switch to IP phone mode
3. Dial the destination number to make calls. For example, ATA
A (with number 1001) dial the keypad
with number 1002 (ATA
B) or reversely make calls from SIP client (ATA B) to the number 1001 (ATA
A)
40