Filter
Top Products
WGS3 Layer 3 Switch User’s Manual
- 98 -
Parameter Description
Drop Events The total number of events in which packets were dropped due to lack of resources.
Bytes Total number of bytes of data received on the network. This statistic can be used as
a reasonable indication of Ethernet utilization.
Frames The total number of frames (bad, broadcast and multicast) received.
Broadcast Frames The total number of good frames received that were directed to the broadcast
address. Note that this does not include multicast packets.
Multicast Frames The total number of good frames received that were directed to this multicast
address.
CRC/Alignment
Errors
The number of CRC/alignment errors (FCS or alignment errors).
Undersize Frames The total number of frames received that were less than 64 octets long (excluding
framing bits, but including FCS octets) and were otherwise well formed. Oversize
Frames The total number of frames received that were longer than 1518 octets
(excluding framing bits, but including FCS octets) and were otherwise well formed.
Fragments The total number of frames received that were less than 64 octets in length
(excluding framing bits, but including FCS octets) and had either an FCS or
alignment error.
Jabbers The total number of frames received that were longer than 1518 octets (excluding
framing bits, but including FCS octets), and had either an FCS or alignment error.
Collisions The best estimate of the total number of collisions on this Ethernet segment.
64 Byte Frames The total number of frames (including bad packets) received and transmitted that
were 64 octets in length(excluding framing bits but including FCS octets).
65-127 Byte
Frames
128-255 Byte
Frames
256-511 Byte
Frames
512-1023 Byte
Frames
1024-1518 Byte
Frames
1519-1536 Byte
Frames
The total number of frames (including bad packets) received and transmitted where
the number of octets fall within the specified range (excluding framing bits but
including FCS octets).
NOTE: Statistics are refreshed every 10 seconds by default (See “4.4.2 Configuring the Serial Port”).