Plasmon FS3102 Computer Hardware User Manual


 
Raidtec FS3102 Hardware Installation Guide Version 1.0 6
1.5 FCC Radio Frequency Interference Statement
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in strict
accordance with the manufacturer’s instructions, it may cause interference to radio and television reception.
The limits are designed to provide reasonable protection against interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A computing device in
accordance with the specifications in Subpart B of Part 15 of FCC rules.
If this equipment does cause interference to radio or television reception, the user is encouraged to try one or
more of the following corrective measures:
Reorient the receiving antenna.
Relocate the computer with respect to the receiver.
Move the computer away from the receiver.
Plug the computer into a different outlet so that computer and receiver are on different branch circuits.
Consult the dealer or an experienced radio/television technician for additional suggestions.
1.6 FCC Booklet Information
The following booklet, prepared by the Federal Communications Commission, may also be helpful in
resolving interference issues:
How to Identify and Resolve Radio/TV Interference Problems.
This booklet is available from the U.S. Government Printing Office, Washington, DC 20401,
Stock No. 004-000-00345-4.
1.7 Shielded Cables
Shielded Interference Cable(s) must be used according to FCC 15.838d.
1.8 Compliance
1.8.1 CANADA:
This digital apparatus does not exceed the Class A limits for noise emissions from digital apparatus set out in
the Radio Interference Regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.
1.8.2 EUROPE:
This product was designed, developed, and manufactured under
an NQA registered I.S. EN ISO 9001-2000 quality system.
This device complies with EU EMC Directive 89/336/EEC and was
assessed to the requirements of the following:
EN 55022-1994+A1, A2 CISPR 22 Class A.
EN 50082-1-1997 (EN 61000-4-2,3,4,5,6,11).