Polycom A2400 Network Hardware User Manual


 
Configuration Guide
PN: 1725-36080-001_J.doc
20
Dynamic RF Management —
ARM Aware Scanning
If Adaptive Radio Resource Management (ARM) Aware Scanning (RF
scanning) is included in your firmware release, it can be enabled
through the command line interface as follows:
configure terminal
ap location x.y.z
phy-type g
arm scanning enable
arm assignment single-band
arm voip-aware-scan enable
phy-type a
arm scanning enable
arm assignment single-band
arm voip-aware-scan enable
write mem
This feature was enabled during VIEW Certification testing in a
screen room (strong signals in a clean environment). A real-world
test with interfering RF signals was not simulated.