Filter
Top Products
Configuration Guide
PN: 1725-36080-001_J.doc
28
CLI Commands to Set Up Subnet Roaming
Commands for the master switch (the Aruba 800)
Configure terminal
ip default-gateway <ip_addr of router>
ap location 1.1.0 (#ap connected to 800)
lms-ip <ip_addr of 800 switch>
ap location 1.2.0 (#ap connected to 6000)
lms-ip <ip_addr of 6000 switch>
ip route 224.0.0.0 255.0.0.0 <ip_addr of SpectraLink
gateway>
exit
write mem
Commands for the local switch (the Aruba 6000)
The AP’s IP address must be on the same subnet as the switch.
Configure terminal
masterip <ip address of the master >
interface loopback
ip address <ip_addr of the 6000>
vlan 1
interface vlan 1
ip address <ip_addr of the 6000> <netmask>
interface fastethernet <port>
switchport access vlan 1 (only if the port is an
access port)
trusted
no shut
!
ip default-gateway <ip_addr of router>
!
exit
write mem
After the master switch IP address and the local switch IP address are
configured on the local switch, the switch needs to be rebooted prior
to use.