Filter
Top Products
Chapter 1-Hardware Description
1-8
Installing the RMX 1500
For detailed instructions, precautions and requirements for installing the RMX
1500 refer to the Polycom RMX 1500 Hardware Guide.
The following procedures have to be performed to install the RMX 1500 in
your site:
• Unpacking the RMX 1500
• Installing the RM
X in a rack or as a standalone
• Connecting the RM
X 1500 to the power source
• Connecting the network (LA
N, IP and ISDN) cables to the RMX.
Unpacking the RMX 1500
To unpack and lift the RMX 1500:
1 When you receive th
e RMX 1500 packing case, inspect the equipment
for damage and verify that the components match the packing slip.
2 Open
the top cover of the packing case.
Two boxes are placed on the top Stratocell®, labelled:
— Installation Accessories. This
kit contains the power cables and a
Disk-on Key (DOK).
— Rack Installation Accessories.
This kit contains the accessories for
the 19”/23” racks as follows:
Write down the RMX’s serial number that is on a sticker on the back of the unit.
It will be needed for product registration later in the process.
Table 1-5 19” & 23” Rack Installation Accessories Package
Item ID Description Quantity
MEC2791A-L0 Chassis runners (60cm in length)
sui
table for installation within 60cm of
inter spaces (front-to-rear stands).
The chassis runners are required
when mounting the RMX 1500 on
19”/23” racks.
2