Filter
Top Products
Polycom RMX 1500 Hardware Guide
1-11
Connecting the RMX 1500 to AC Power
• Do not connect the green or green-yellow wire to the system single-point
ground screw.
• Only the AC Power cable supplied by Polycom should be used.
• The size of the protective earthing conductor should be a minimum of
10AWG.
• The outlet intended for connecting the power cord must be protected with
an external overcurrent protection device either in building or in the rack
with the rating not higher than 20Amp.
• Do not use an Extension cord with the cable.
1 Make sure that the power button is switched OFF on the RMX 1500.
ON/OFF
button
USB Slot
2 Insert the power cable into the power connector on the rear panel of
the RMX 1500.