Filter
Top Products
Part 10
full screen display of Windows DOS box should be avoided.
E. APPLICATION LIMITATION
The USB touch is not applicable for OS other than Windows as USB mouse is
not supported in DOS environment. The USB touch is also not applicable
when the monitor is used to be the extended screen in multiple monitor
application.
In using the MSR of the side mounted upgrade option for reading a magnetic
stripe card, be sure to insert the card to the bottom with magnetic stripe facing
the mark aside the slot. The movement of the card can be either inserting the
card from the top surface then sliding the card down out of the slot, or sliding
the card upward from the lower side of the slot till it reaches the top end as
long as the card is a standard one. A non-standard card recorded without
complete degaussing prior to recovery may accept only one direction in card
reading.
If the fingerprint sensor option is installed in the side mount kit, please find the
most comfortable angle for the fingerprint taking operation in consideration of
the LCD panel tilt angle and try to align the core of fingerprint in the sensing
area.
IX. LED MODULE INDICATION
• Green: standby
• Blue: power on
When this touch monitor is turned ON, the LED light is in blue. When the
VGA signal vanishes, the monitor shows “No signal” for a while and goes into
standby mode and LED is green. However, the touch panel is still operational.
X. OSD
(ON SCREEN DISPLAY) SCREEN ADJUST FUNCTION
A. OSD buttons
The 4 OSD control buttons are above the power
switch button on left side of the LCD panel.
“OSD” button: To enter OSD setup menu, or to
perform function selected in OSD operation.
“NXT” button: To go to next option function.
“
” “” button: To increase setting value.
“” “” button: To decrease setting value.