Powerware 3110 Power Supply User Manual


 
Installation
3
Powerware
®
3110 User's Guide S LTM-XXXX A Draft 03/01/2001
Quick Startup
The Powerware 3110 provides protection against many power problems,
including power outages. It also provides spike suppression and line
noise filtering to protect your equipment.
1. On 230V Models, plug the UPS power cord into the input
connector on the UPS side panel.
2. Plug the equipment to be protected into the UPS output
receptacles.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
3. Start the UPS by pressing the
switch as shown in Figure 3
or Figure 4 on page 5. The Power indicator illuminates
indicating that power is available from the UPS output
receptacles.
The units beeps and the front panel LEDs illuminate several
times. The green indicator remains on, indicating normal
operation.
If the unit continues to beep, or if the green indicator is off
even though input power is available from the wall outlet, see
Troubleshooting" on page 15.
NOTE Let the unit charge the battery for at least 3 hours. You may use the unit while
the battery charges, but the battery backup runtime will be reduced until the battery is
fully charged. This will take up to 8 hours after a full discharge while the UPS is fully
loaded.
4. Please fill out and return the warranty registration card. If you
are in the USA or Canada and would like to activate the
Transient Voltage Surge Suppression warranty, return the card
within 10 days of installation.