Printek 810 Personal Computer User Manual


 
DT Chassis Printers/Plotters
Safety
6-1
Restriction on Use
Use this equipment only for its intended use as described in this guide.
Do not use power supplied outside the specified voltage/hertz range.
Do not block any openings on the equipment.
Do not use corrosive chemicals or vapors on the equipment.
Do not expose equipment to rain or spills or moisture.
Grounding
This equipment must be grounded to conform with the normative safety standards. Connect
only to a properly grounded outlet.
Power Cord
The power cord supplied with the equipment is rated and approved for service to this
equipment.
Do not operate the equipment if it has a damaged power cord or plug.
Do not immerse the power cord or plug in water.
Do not use a power cord other than that supplied with the equipment.
Serviceability
There are no user-serviceable parts inside the equipment. Refer all service to a qualified
service technician.
Regulatory
Compliance
FCC Compliance
This unit has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his
own expense.
CE Compliance
The manufacturer declares that this product conforms to the following standards or other
normative documents:
EMC: EN 55022:1994 Limits and Methods of Measurements of Radio Interference
Characteristics of Information Technology Equipment, Class A, including
amendments A1:1995, A2:1997
EN 50024:1998 Limits and method of measurement of Immunity
characteristics of Information technology equipment
Safety: EN 60950:1992 Safety of information technology equipment including
electrical business equipment, including amendments A1:1993, A2:1993,
A3:1995, A4:1997, A11:1997