Filter
Top Products
Positioning The Media Sensors
25
QUICK SETUP Configuration Menu
QUICK SETUP
Validator Funct.
(6)
Print Intensity
6 ips* 2-10 ips
(1)
Print Speed
Print Mode
Paper Feed Shift
Label Width
Label Length
Orientation
Transfer* Direct
4.1, 6.6, or 8.5 inches*
(2)(4)
Portrait* Landscape Inv. Portrait Inv. Landscape
-3* -15 to 15
00.1 to 8.5 inches
(4)
0.00 inches*
(2)
4 or 6 inches*
(2)(4)
00.1 to 99.0 inches
(5)
-0.50 to X inches
(3)
Run Calibrate
Auto Calibrate
1* 1-8
Factory* 1-8
Save Config.
Power-Up Config.
Ver Image Shift
Hor Image Shift
0.00 inches*
(2)
-1.00 to 1.00 inches 0.00 inches*
(2)
-1.00 to X inches
(3)
Enable* Disable
Tear-Off Strip* Tear-Off Peel-Off Cut
Media Handling
Continuous
Gap/Mark Sensor
Disable* Mark Gap Advanced NotchAdvanced Gap
Notes:
* = Factory Default
1
Maximum value depends on the width of the
printer model and printhead.
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL)
See the T5000e User’s Manual for information.
3
Based on the current value setting for the Label
Length menu, up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the
printer model.
5
Maximum value depends on model width and size
of DRAM installed.
6
Appears only if the validator option is installed.