Filter
Top Products
Step 7: Setting the IP Address
27
Setting up with the CLU
1. At the administrator@cli> prompt, type menu and press Enter.
The CLU main menu appears.
Figure 24.CLU main menu
2. With Quick Setup highlighted, press Enter.
The first Quick Setup screen enables you to make Date and Time settings.
Setting system date and time
1. Press the arrow keys to highlight System Date.
2. Press the backspace key to erase the current date.
3. Type the new date.
4. Follow the same procedure to set the System Time.
5. Press Ctrl-A to save these settings and move to the Management Port
configuration screen.
Making Management Port settings
By default, DHCP is disabled on VTrak and the default Management Port
address is set to 10.0.0.1.
Note that the IP address described here belongs to the VTrak subsystem, not to
the RAID controller. Use this IP address to log into the VTrak over your network.
Manual IP settings
To make Management Port settings manually:
1. Press the arrow keys to highlight IP Address.
2. Press the backspace key to erase the current IP Address.