Filter
Top Products
5
2. Quick Installation
You may follow the quick installation and configuration steps,
listed below, if all of the following conditions are true:
❑ You will use all of the software default values.
❑ You intend to use the Ethernet Adapter to connect an
Ethernet-ready device to an existing RangeLAN2
network.
❑ The existing network uses a Domain number between 0
and 9.
❑ You do not intend to set Security IDs on your network.
❑ You do not intend to configure the Ethernet Adapter
with an IP address.
Follow the steps below to install the RangeLAN2 792x Ethernet
Adapter:
1. Firmly screw the antenna onto its connector in a clock-
wise rotation. The antenna connector is located on the
side of the unit as shown in Figure 2.
Note:
Government regulatory agencies mandate that the
antenna not be alterable. Therefore, the RangeLAN2
Ethernet Adapter uses a custom antenna connector.
Do not attempt to use a non-certified Proxim antenna,
or you may damage the connector and the Ethernet
Adapter.